TUNE Prince IS Boost rear hub
The Prince IS6 in Boost standard is the hub chosen by elite racers around the world! A super light hubshell, Ceramic- or Endurance-bearings and different types of freehub shells offer you countless customizing options. Each material was selected to achieve the lowest weight possible. The aerospace grade Aluminium with increased fatigue strength has been used to obtain the fine geometrical tolerances and the complex shape. The flange geometry has been optimized to increase the lateral stiffness of the wheel. Configure the hub you need: with Ceramic Bearings and Carbon Endcaps to challenge yourself during XCO races or Endurance Bearings with Aluminium Endcaps to switch the XC marathon mode on.
weight starting from: 207,6g
recommended spokes: SAPIM CX-Ray, SAPIM D-Light
max. spoke tension 1100N
max. rider weight: 90kg
max.system weight: 105kg
field of use: MTB
flange distance left: 35,2mm
flange distance right: 22,2mm
pitch circle left: 47mm
pitch circle right: 57mm
diameter spoke holes 2,4mm
offset spoke hole left flange 1,5mm
offset spoke hole right flange 1,5mm
spoke lacing pattern: 28/32 spokes with 3-cross lacing
configuration: Endurance Bearing with Endurance freehub body/Ceramic Bearing with Endurance freehub body
scope of delivery: hub and corresponding packaging if applicable
notice: Remove the 1.8mm spacer on your freehub to switch from HG10 to HG11 and from XD to XDR.
Remove the two spacers (1.8mm and 0.6mm) on your freehub to switch from HG10 to HG12.
Threadlock residue must be removed before installation. The brake rotor must be fastened with a calibrated torque wrench to a max torque of 5Nm.
*XD-Compatible licensed by SRAM
*XDR Compatible licensed by SRAM
*microspline system licensed by Shimano
There are no reviews yet.